Skip to content
Your Cart
Your cart is empty
How to attach engraved clip beads to your bracelet
Step-by-step guide
Step 1: Place the upper bead where you want it on the bracelet
- Place the engraved bead on your bracelet
- Press it on just firmly enough that it sits loosely but stays in place on its own

Step 2: Hook the lower, unengraved bead in on the side without the pin
- Make sure the side without the pin faces you on both bead parts
- Then hook the unengraved bead into the engraved bead

Step 3: Clip the bead parts together
- Make sure both bead parts are lying parallel
- Then press the other side of the beads (with the pins) together
- You should hear a *click* when it locks in place
- Press the bead together very firmly on both sides once more

Step 4: Check for a good, secure hold
- Move the bead back and forth
- Give the bracelet a little tug
- Ideally, the bead should sit firmly and only move with some force
